BRIGHTICONIC: MK47 USER GUIDE PAGE
Everything You Need to Get Your
MK47 Working Right
Pre-setup checklist, step-by-step activation, bait guide, charging schedule, species ID, troubleshooting, and FAQ — all in one place.
This device contains a high-speed mechanical strike trigger. While the enclosed chamber significantly reduces accidental access, always deploy in areas inaccessible to young children. Never allow children to handle or operate this device.
Connect via USB-C and charge until the indicator light confirms a full charge (approx. 4 hours). A partially charged trap may not deliver a full-power strike on first deployment.
What's In the Box
Watch Before You Set Up
Covers placement, bait loading, activation, and disposal.
5 Steps to Your First Catch
Follow in order. Most failures come from skipping Step 3.
Charge Fully First
Connect via USB-C (cable included). Charge for approximately 4 hours until the indicator light confirms full charge. Do not deploy until fully charged.
Wear Gloves & Wipe the Device
Put on the included gloves before touching anything. Even brief bare-hand contact deposits enough human scent to deter rodents for days. Wipe the entire device thoroughly with a clean damp cloth to remove any scent from manufacturing and shipping.
Familiarization Phase — No Bait for 3–5 Days CRITICAL
Place the trap in position with no bait at all for the first 3–5 days. Whether it is on or off during this period does not matter. Rodents practice neophobia — fear of new objects — and will avoid anything unfamiliar in their environment. Let them accept the trap as a normal part of their surroundings before introducing any food.
Load Bait Into the Top Dome Chamber
After 3–5 days, open the clear dome on the top of the unit — this is the bait and PIR sensor chamber. Apply a pea-sized amount of peanut butter or Nutella using a cotton swab. Never use bare fingers. Keep the trap off while testing bait.
Activate Once Bait Is Being Taken
Check daily. When you see consistent bait nibbling — the rodents trust both the trap and the food — switch the trap on. It will auto-reset after every activation. Check every 48 hours initially, then weekly once activity stabilises.
How Often Do I Need to Charge It?
2200mAh battery · Up to 60 days standby · 4-hour USB-C recharge
Indoor / Low Activity
Spare rooms, attic, basement off-season. Check charge every 4–6 weeks.
Active Infestation
Kitchen, garage, crawl space with frequent triggers. Each activation draws extra power.
Barn / Outdoor
Harvest season, grain storage, high rodent pressure. Build recharging into regular walk-throughs.
Not Catching Anything?
Bait isn't being touched at all
Rodents are still in the neophobia phase — they don't trust the new object yet. Wait longer (up to 7 days). Check for human scent: rewipe the trap with a damp cloth using gloves. Remove all competing food sources nearby (pet food, compost, bird feeders).
Bait disappears but nothing is caught
The rodent is feeding without fully entering the detection zone. Use less bait — pea-sized only, placed deeper in the dome. Do not activate the trap yet; continue pre-baiting until the feeding is consistent.
Trap is firing but not catching
The strike is triggering too late. The rodent may be detecting it and retreating. Ensure the trap opening is flush against a wall at a 90° angle to the rodent's run path. Check that the Hall safety sensor is properly engaged (trap is sitting correctly).
Trap isn't activating at all
Check the battery charge — an insufficiently charged battery may prevent operation. Confirm the power switch is in the ON position. Verify the magnetic Hall sensor is engaged (trap must be in the correct mounted position to operate).
Wrong rodent species / bait not working
Follow the 14-day bait protocol: Days 1–5 no bait (familiarisation). Days 6–8 peanut butter + honey. Days 9–11 Nutella. Days 12–14 protein bait (dried meat, tallow, anise). Trap stays OFF during all testing. Activate only after consistent nibbling is confirmed.
Trap keeps getting knocked over (farm/barn)
Use the included wall mounting screws to secure the trap to a baseboard or wall. Keeps the trap properly aligned and ensures the Hall sensor remains engaged at all times.
Product Specifications
Common Questions
Questions not covered here? Our support team is ready to help.
Contact Support · Full Setup & Bait Guide · User Guide
© Brighticonic · MK47 Rodent Trap · Model X‑PEST MK47 · IP44 · 2200mAh · USB-C